We service both gas and electric furnace systems with manufacturer-trained technicians.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in Big Bend, WI get treated with urgency, not a next-available-Tuesday slot.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
No push toward replacement when a repair genuinely solves the problem.
No-heat calls during freeze warnings get moved to the front of the schedule.
From the first symptom to the final fix, these are the specific furnace repair services our Big Bend-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. This is one of the most requested furnace repair calls we get across Big Bend, WI.
A gas valve that won't open or won't seal is tested with proper manometer readings, not just listened to. This is one of the most requested furnace repair calls we get across Big Bend, WI.
A cracked heat exchanger is a carbon monoxide risk and gets flagged immediately with the furnace shut down if needed. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
A furnace that won't respond to the thermostat at all sometimes traces to a control board fault rather than the burner assembly. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Gas odor reports get immediate safety instructions before dispatch details.
We confirm your Big Bend address and a realistic arrival window.
Flat-rate quote follows the confirmed fault, before repair begins.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Pilot light kept going out every few hours.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
Could be a delayed ignition fault, a failed gas valve, or a limit switch issue — a full diagnostic narrows it down.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
No-heat calls during freeze warnings are prioritized across Big Bend, WI.

Our furnace repair crews are positioned throughout Big Bend, WI to keep response times realistic, not just promised.
☎ Call +1-866-805-8548 for Big Bend Service